To install the AirPort card:

1. Shut down the computer (choose Shut Down from the Special menu) and unplug all cables except the power cord.

   

   Shutting Down the Macintosh Computer

2. Touch the metal PCI access cover on the back of the computer to discharge static electricity.

   Note:Avoid walking around until you have finished installing the card (you could become statically charged and damage your computer).

   

   Discharging Static Electricity

3. Touch the metal shield inside the recessed latch area to discharge static electricity.

   

   Discharging Static

4. Unplug the power cord. Then lift the latch on the side of the computer.

   

   Opening the G4

5. Gently lower the side panel onto a clean, flat surface. It's a good idea to rest it on a soft cloth to avoid scratching the case.

   

   Opening the Side Panel

6. Remove the metal clip and pull the AirPort Card from the iMac AirPort Card adapter. The adapter and clip are not used with your PowerMac.

   

   The AirPort Card, Adapter, and Clip

7. Insert the AirPort Card through the opening in the PCI card guide, and into the connector on the main panel.

   

   Inserting the AirPort Card

8. Connect the antenna cable to the connector on the end of the AirPort Card. The cable is usually stowed on the side of the PCI card guide.

   

   Connecting the Antenna to the AirPort Card

9. Raise the side panel and press it against the case.

   

   Raising the Side Panel

10. Squeeze the side panel until it snaps into place.

    

    Closing the Cover

Next we'll configure the AirPort software. Please click the link below that corresponds to the version of the Mac OS installed on this computer:

• Configuring the AirPort Software Using Mac OS 8.6–9.1

• Configuring the Airport Software Using Mac OS 9.04–9.1